Ubiquiti NanoStation Loco M2

The NanoStation loco M2 Indoor/Outdoor airMAX CPE from Ubiquiti Networks is a cost-effective and reliable solution for high performance. It features up to 10km of range performance, 25+Mb/s of throughput performance, an intuitive AirOS by Ubiquiti. The NanoStation Loco also features broadband wireless CPE technology. NanoStation5 Loco exhibits optimal antenna performance. Usage Forget Ethernet cable, the Ubiquiti NanoStation Loco M2 is ideal for bridging networks or sharing broadband across distance. To install, place the units at either end of the network and connect both to Ethernet cables - for example, connect the first unit into your modem at location one, and connect the second into an Ethernet switch or WiFi access point at the other location. Up to six remote buildings can be linked over one connection with the NanoBridge supporting AP-WDS. This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple - no routing configuration, all protocols (DHCP, DNS, etc) just work Management of the Ubiquiti NanoStation Loco M2 device couldn't be easier with SSH and SNMP protocol support and an intuitive HTTP interface. 802.11b/g/n WiFi Access Point Login to the AirOS management software and set to AP mode to create a high performance, long range WiFi network With a wide directional broadcast angle the NanoStation Loco M2 is ideal for covering sports grounds and outdoor areas with a sector-by-sector approach. You can learn how to set up the NanoStation Loco M2 as a long range WiFi access point by following their Quick Start Installation Manual. Ready to Install This unit has all networking hardware integrated and is completely weatherproof for permanent installation in even the toughest environments. Signal strength indicators allow for quick and easy alignment. For best performance the unit should be roof mounted, high and clear of obstructions, via its integrated pole mounting bracket. The units are powered via Power over Ethernet (PoE) - simply plug one end of the Ethernet cable into the NanoStation Loco M2, and the other into the PoE Injector (which is plugged into AC power) - this allows one cable to power the unit and also carry network traffic. We recommend using Cat6 Outdoor UV Shielded Cable with this unit.